Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

How do I re-wax a Ruggedwear bag, and which wax should I use?

Validated 13 November 2026

Applies to

Line
Domke
Attribute
Ruggedwear

Resolution

  1. 01

    Empty the bag and take out the insert. Brush loose dirt off the outside with a dry brush and let the canvas dry completely.

  2. 02

    Apply the wax to the canvas by rubbing it on the material, using the tin supplied with the bag. Work one panel at a time and cover the seams and the base, which take the most water.

  3. 03

    Heat the applied wax with a hair dryer to seal the fabric. The wax turns glossy and sinks into the weave as it melts.

  4. 04

    Rub the warm surface with a clean cotton cloth to spread the melted wax evenly and take off any surplus. Surplus wax left on the surface is what transfers onto clothing and gear.

  5. 05

    Leave the bag to cool at room temperature before repacking it.

Cause

Tiffen's own article treats a RuggedWear bag that has stopped repelling water as a wax problem and prescribes new wax as the remedy, so the repellency is a property of the wax coating and goes when the coating goes.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question