Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

How do I remove a cross-threaded filter without damaging the lens?

Validated 13 November 2026

Applies to

Line
Filters

Resolution

  1. 01

    Stop turning in either direction. Each further turn drives the damaged thread further into the mating thread.

  2. 02

    Look at the seam between the filter ring and the lens, from the side, at eye level. A cross-threaded filter sits at a tilt: the gap is closed on one side of the lens and open on the other. A filter that is merely tight sits square all the way round.

  3. 03

    Press evenly on the high side, where the gap is open, with a thumb, while turning the filter counterclockwise with the other hand. The aim is to bring the filter square to the lens axis so the threads line up again.

  4. 04

    Spread the turning force around the ring. A flat rubber jar opener laid across the face of the filter grips the full circumference. A two-point grip squeezes an aluminum ring out of round.

  5. 05

    Stop the moment the filter turns freely and lift it straight off. Inspect the lens thread with a raking light before fitting anything else to it.

  6. 06

    Photograph the assembly if it stays bound: one frame straight on, one from the side showing the tilt.

  7. 07

    Send the photographs, the filter and lens models, and your proof of purchase to Tiffen support at https://tiffen.com/pages/contact.

Cause

A screw thread engages only when the two parts start square to one another. When a filter is started at an angle, the crest of its thread bears on the crest of the lens thread, and turning drives one crest across the other.

The deformation this leaves is what resists unscrewing, and it grows with every turn in either direction.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question