Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

How do I remove a filter that will not unscrew?

Validated 13 November 2026

Applies to

Line
Filters

Resolution

  1. 01

    Stop turning once the resistance stops changing. A filter that will move turns a little further with each attempt. A filter that gives the same resistance every time is bound, and more torque deforms the ring.

  2. 02

    Support the lens by its barrel, close to the mount, with the camera off the tripod and off your neck. Keep both hands on the assembly.

  3. 03

    Turn the filter ring counterclockwise, viewed from the front of the lens.

  4. 04

    Spread the grip around the whole ring. A flat rubber jar opener across the face of the filter, or a filter wrench matched to the thread size, applies force evenly around the circumference. A grip on two points squeezes the ring out of round and tightens it further.

  5. 05

    Turn slowly and stop at the first step or crunch you feel. That is thread damage progressing, and the next quarter turn makes the filter harder to remove.

  6. 06

    Photograph the filter on the lens if it stays bound. One frame straight on showing the seam between filter and lens, and one from the side showing whether the filter sits square.

  7. 07

    Send the photographs, the lens and filter model, and your proof of purchase to Tiffen support at https://tiffen.com/pages/contact. Tiffen filters carry a 10 year warranty, with 1 year on IR and IRND filters and on Advantix and Apex XLE Long Exposure filters.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question