Is the Volt weatherproof?
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Volt
Resolution
- 01
Treat the Volt as a device to be protected from water. Tiffen's published answer is that if the Volt is being exposed to water or other contaminants, it is always good to protect it as much as possible.
- 02
Order the rain cover for the drive unit. Contact your Steadicam representative and ask for part number VOLTRC.
- 03
Keep the rig inside the published temperature range. The recommended operating temperature for the Volt is between minus 10 and plus 60 degrees Celsius, which is 14 to 140 degrees Fahrenheit.
- 04
Allow warm-up time in the cold. Lower operating temperatures produce increasingly sluggish response, so let the Volt warm up for a few minutes before operating in cold conditions.
- 05
Clean it by wiping it down with a damp lint-free cloth. Use a small brush for tight areas.
- 06
Contact Tiffen Steadicam service if the Volt has been immersed or exposed to salt water, before powering it up again.
Cause
The Volt drive unit sits on the outside of the gimbal and carries a motor, belts and pulleys, a magnetic encoder ring and an electrical connector, all exposed to the air. Tiffen publishes a rain cover for that unit and publishes no sealing specification.