The Volt LEDs come on and then fade off.
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Volt
Resolution
- 01
Change the batteries first. Tiffen's published answer is that the most likely cause is low battery voltage and the batteries need to be changed.
- 02
Measure the supply at the Volt's 12V IN port with the rig powered up. The Volt is designed to operate from 12 to 17 Vdc. Below 12V the motor power and the reliability of operation both start to fall away.
- 03
Watch which LEDs go out. When the supply drops too low, the LEDs on the motor drive go off while the LEDs on the control box may stay on. Motor power comes back automatically once the voltage recovers.
- 04
Check whether a camera is drawing the pack down. A high current camera can take enough that the Volt cannot get the voltage it needs. On a 12V rig the three published remedies are to set the batteries in parallel, fit a third battery mount, or run the Volt from a dedicated battery.
- 05
Fit an accessory power cable to an independent battery via a D-tap connector for builds with a heavy power draw. This is Tiffen's published answer for setups that keep starving the Volt.
- 06
Check the gimbal cable is attached at both ends. The control box will not power on without the gimbal cable attached to the motor unit.
- 07
Inspect the gimbal cable for damage, and confirm it has enough slack and is not snagged.
- 08
Confirm polarity on any aftermarket power cable before connecting it.
- 09
If the control box blue LED stays lit and nothing lights on the drive unit with a stable supply above 12V, the fault is in hardware: the control box or Volt PCB, the Volt cable, or the motor drive. Contact Tiffen Steadicam service with the sled model, the Volt version, the measured voltage at the 12V IN port, and which LEDs are lit.
Cause
The Volt runs its motors directly from sled battery voltage, and the sled output is unregulated. A nominal 12V output on an M-1 varies approximately from 11 to 17 volts depending on the pack and its state of charge, so the voltage the Volt sees falls steadily as the batteries deplete.
The Volt's stated operating window is 12 to 17 Vdc. When the applied voltage falls below the bottom of that window the motor systems are turned off, which is why the drive unit LEDs go out while the control box LEDs can stay lit. It is a protective shutdown and it reverses itself: once the voltage recovers, motor power is turned on again automatically.
A high current camera on the same pack produces the same result faster, because the camera's draw pulls the pack voltage down under load even when the pack has charge left in it.