Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

How do I set arm ride height and travel for my payload?

Validated 13 November 2026

Applies to

Line
Steadicam
Attribute
Any arm

Resolution

  1. 01

    Preset the ride before you pick up the sled. The Ride knob turns only when the arm segment is raised to its highest unloaded position, so setting it first is easier. Start with both Ride knobs at the middle of their travel, about 15 threads visible.

  2. 02

    Put the vest on, attach the arm, and undock the rig. All lift adjustments are made while wearing the rig, standing properly, with your normal threads set at the vest.

  3. 03

    Move the arm to the middle of its boom range and let it rise or fall without letting go of the sled.

  4. 04

    Adjust the forearm section first, the one nearest the sled. Raise or lower the section slightly to find the angle where the lift knob turns easily, then turn the knob until the forearm settles about 5 degrees above horizontal. Never force the knob and never use a tool on it.

  5. 05

    Adjust the upper arm section next, so it follows the forearm as you boom fully up and down. Both sections should come to rest 5 to 10 degrees above horizontal.

  6. 06

    Estimate large changes by turn count. On a G-Series arm the Lift knob has 30 turns of range, and each turn adds or subtracts about 1.5 pounds (0.7 kg) of lift.

  7. 07

    Re-adjust the ride once the lift is set. Turn the Ride knob counterclockwise until the segment begins to lock at the extremes of travel, then back clockwise a couple of turns. Watch both sections as you boom: if the upper arm hesitates in the middle of its range, increase its iso or reduce the forearm's.

  8. 08

    Set a different float angle if the shot needs it. Heavier cameras and high boom heights are easier with the sections floating at +25 degrees or more, and the arm can be set to hang lower for low boom heights. The ride does not need re-adjusting when you move the float point.

  9. 09

    Check the arm post engagement whenever you change posts: at least 1.125 inches (2.8cm) of post above the arm, and on the G-70x2 also at least 0.25 inches (6mm) below. Secure the post lock.

Cause

The two knobs on each arm segment do different jobs. The Lift knob sets the spring preload, which sets the weight the segment carries and therefore the angle at which it floats. The Ride knob sets the length of the active link in the Geo geometry, which sets how closely the lifting force tracks the load across the boom range.

Lift and ride interact, which is why the order matters and why the sequence ends with a ride re-check. The lift knobs turn only in a narrow band just above horizontal because that is where the internal geometry unloads the adjuster; forcing them outside that band works against the spring load.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question