What does iso-elastic mean, and is my arm faulty if it returns to center?
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Any arm
Resolution
- 01
Read the definition Tiffen publishes. Iso-elasticity is the vertical bandwidth through which the arm's lifting power closely approximates the load. Inside that band, the arm supports the sled at whatever height you put it, so booming up or down takes almost no effort.
- 02
Expect the arm to return toward its float angle outside that band. The float angle is set by the Lift knob, and the arm is designed to seek it. An arm that drifts back to its set angle from the extremes of travel is behaving as designed.
- 03
Test properly before deciding anything. Wear the rig, stand correctly, boom the arm fully up and fully down, and watch both sections.
- 04
Set the lift so each arm section floats about 5 to 10 degrees above horizontal at mid boom. Adjust the forearm section first, then the upper arm so it tracks the forearm.
- 05
Adjust the ride for the load. Turn the Ride knob counterclockwise to increase iso-elasticity until a segment begins to lock at the extremes of travel, then back clockwise a couple of turns.
- 06
Re-check the ride whenever the payload changes materially. With the same ride setting, a G-Series arm becomes progressively less iso-elastic as the lift is increased, so a heavier build needs more iso and a lighter one needs less.
- 07
Preset both Ride knobs to the middle of their travel, about 20 to 25 threads visible, if you have lost your setting. Note the thread count and the camera weight once you find a feel you like.
- 08
Treat a section that hangs up hard at one end of travel, or that lags the other section badly at every setting, as a service question and contact Tiffen Steadicam service with the arm model and the payload weight.
Cause
A plain spring arm applies a force proportional to its deflection, so it pushes the sled back to one height. The G-Series geometry uses adjustable-length crankshafts that rock the spring termination as the arm booms, so the lifting force stays close to the load across a range of heights.
That range is finite. Inside it the arm is close to weightless in the vertical axis. Outside it the geometry runs out and the spring force again exceeds or falls short of the load, so the arm drives back toward its float angle. The Ride knob sets how wide the range is, and the width available falls as the lift setting rises.