Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

What is the correct way to disconnect the arm at the end of a take?

Validated 13 November 2026

Applies to

Line
Steadicam

Resolution

  1. 01

    Set the stand height before the take. The gimbal should sit slightly below your shoulders when docked, and the stand should be sandbagged or steadied by an assistant.

  2. 02

    Step up next to the docking stand with the camera aimed across your body to your operating side.

  3. 03

    Insert the center post into the bracket and rest the stage on the docking yoke. On a Volt rig, dock on the gimbal in the Tiffen padded dock instead.

  4. 04

    Insert the aircraft pin back into the docking yoke to secure the sled before you release any weight.

  5. 05

    Bow from the waist and step back.

  6. 06

    Move your left hand to the gimbal handle and your right hand to the arm.

  7. 07

    Lift the gimbal handle and let the arm post slide out of the gimbal mounting hole. Find the angle at which it slips out. Do not force it and do not bend your knees.

  8. 08

    Keep a hand on the free end of the arm as it comes clear.

  9. 09

    Between takes when there is no time to dock, relieve muscle tension by keeping the rig close to your body on either side, or by clasping the camera close to your chest.

Cause

The arm post is a plain sliding fit into the gimbal's arm post receiver. It comes out when the receiver is lifted clear of it at the right angle, and it binds when the two are misaligned, which is what makes forcing it both hard and unnecessary.

The order of the steps is set by where the load is. Until the aircraft pin is in the docking yoke, the arm is still carrying the sled, so releasing the arm first drops the rig. Once the pin is in, the sled's weight is on the stand and the arm is unloaded, at which point the arm springs are free to throw the arm end around if nobody keeps a grip on it.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question