Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

The arm over-lifts at its minimum adjustment.

Validated 13 November 2026

Applies to

Line
Steadicam
Attribute
Any arm

Resolution

  1. 01

    Weigh the loaded sled: camera, lens, monitor, battery, balance weights and every accessory that flies with it.

  2. 02

    Compare that figure against the arm's minimum lift capacity. The published minima are 13 lb (5.9 kg) for the G-70x and G-70x2, 12 lb (5.4 kg) for the G-50x, 12 lb (5.4 kg) for the G-40 and 18 lb for the X3. An arm set to its lowest lift still supports its rated minimum, so a sled below that figure will be pushed up.

  3. 03

    Confirm you are turning the knob in the right position. The lift knobs turn only when the arm segments sit slightly above horizontal and the arm is loaded. A knob turned at the wrong angle may not have moved the adjuster at all. Never force it.

  4. 04

    Count the turns. A G-Series Lift knob has 30 turns of range and each turn changes the lift by about 1.5 pounds (0.7 kg), so you can work out whether the adjuster has actually reached its stop.

  5. 05

    Add mass to the sled if the payload is below the arm's minimum. Tiffen's published remedy for a light camera is a larger battery, an accessory such as an audio receiver, or four or more balance weights beneath the stage, added symmetrically.

  6. 06

    Extend the post and move the monitor and battery out at the same time. This raises the sled weight and the inertia together.

  7. 07

    Contact Tiffen Steadicam service with the arm model, the sled weight and the thread count at the stop if the sled weight is comfortably inside the arm's published range and the section still rises at minimum lift.

Cause

Each arm segment is a spring set with an adjustable preload. The Lift knob changes the preload, and the published range of the knob defines the range of loads the segment can be set to carry.

Below the bottom of that range the spring still delivers more force than the load requires at every setting, so the segment rises to the top of its travel and stays there. Adding mass to the sled brings the load back inside the adjuster's range, which is why Tiffen's published remedy for a light camera is to add weight, and why continuing to turn the knob changes nothing.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question