Why does the arm judder at the bottom of its range?
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Any arm
Resolution
- 01
Reproduce it standing still. Wear the rig, boom fully down, and watch which section judders and at what point in its travel.
- 02
Reduce the ride on the section that judders. Too much iso-elasticity makes an arm segment lock at the upper or lower extreme of boom travel, and that lock releasing and re-catching is felt as a judder. Turn the Ride knob clockwise a couple of turns and re-test.
- 03
If both sections are involved, reset the ride from scratch. Turn the Ride knob counterclockwise until the segment begins to lock at the extremes, then back clockwise a couple of turns.
- 04
Match the ride to the load. A heavier build needs the Ride knob turned to increase iso-elasticity; a lighter build needs it reduced.
- 05
Check the lift after any ride change. Set each section to float 5 to 10 degrees above horizontal at mid boom, forearm first, then re-check the ride.
- 06
Watch the upper arm as you boom. If it hesitates or dwells in the middle of its range, it is not iso enough to work with the forearm: increase the iso on the upper arm, or reduce it on the forearm if the upper arm then locks.
- 07
Confirm whether you are simply reaching the end of travel. G-Series arms carry soft bumpers at each end of travel, so reaching the limit gives a cushioned stop.
- 08
If you use a back-mounted vest, set the kick-back link inward. With any back-mounted vest all arms are more extended from the sled to the socket block, and leaning back puts the upper arm's end block in a position where it is more likely to lock up.
- 09
Contact Tiffen Steadicam service with the arm model and the sled weight if the judder persists across the full range of ride settings.
Cause
The Geo geometry uses adjustable-length crankshafts to rock the spring termination as the arm booms, which keeps the lifting force close to the load across the travel. The Ride knob sets the length of that active link.
Set too long for the load, the geometry over-compensates near the ends of travel and the segment locks there. A locked segment releases in steps as the operator pushes through it, which is the judder. Set too short, the arm tracks poorly through the middle instead. Because the achievable iso-elasticity falls as the lift setting rises, the correct ride setting is a function of the payload, and it moves as the payload changes.