Does a variable ND reduce reflections the way a polarizer does?
Validated 13 November 2026
Applies to
- Line
- Filters
- Attribute
- Variable ND
Resolution
- 01
Expect a polarizing effect, because the filter is made of polarizers. Tiffen states that its variable ND is made of two circular polarizing filters.
- 02
Test it on the reflection you care about. Point the camera at the glass, water or paint in question, rotate the filter slowly through its full range, and watch the reflection while the image also darkens.
- 03
Accept that the two move together. The rotation that reduces the reflection most is one particular position, and that position is also one particular density. You can choose either one, and the other follows.
- 04
Use a fixed ND with a separate polarizer where you need to set both. Tiffen states this directly:
If you wish to shoot with a ND filter and a CP filter at the same time, we recommend using a set stop value ND filter instead of a VND.
- 05
Do not add a polarizer on top of the variable ND. Tiffen states that adding a third circular polarizer causes cross polarization issues and does not recommend it.
- 06
Check the geometry before concluding the filter is doing nothing. A reflection is reducible only when the angle between the camera, the surface and the light source puts it in the plane the filter rejects. On some angles rotating changes the exposure and leaves the reflection where it was.
Cause
A variable ND is two circular polarizers in one mount, one fixed and one rotating. The angle between the two sets how much light passes, and that is the density control.
The pair also has an absolute orientation in the mount, and that orientation decides which plane of polarized light is rejected, which is what reduces a reflection. Turning the front ring changes both at once, so on this filter the density and the reflection reduction are one control.