Why does a dark X appear across my frame at high variable ND density?
Validated 13 November 2026
Applies to
- Line
- Filters
- Attribute
- Variable ND, screw-in
Resolution
- 01
Rotate the filter toward its lighter end until the cross clears. The cross appears at the dense end of the rotation and disappears as density is reduced. Note the position where it clears and stay below it.
- 02
Recover the lost stops elsewhere in the exposure. Close the aperture, reduce ISO, or increase shutter angle. Keep the filter below the density identified in step 1.
- 03
Use a fixed ND where the required density is above that limit. A fixed ND is a single density with no rotating polarizer, so the cross does not occur at any strength.
- 04
Test the range on the widest lens you intend to use. The cross appears at lower densities on wider lenses. Rotate through the full range on that lens and record the usable limit before the shoot.
Cause
A variable ND consists of two polarizing layers, one fixed and one rotating. Density is set by the angle between them.
As that angle approaches the crossed position, transmission becomes highly sensitive to small changes in the angle at which light passes through both layers. Light reaching the corners of the frame passes through at a different angle from light reaching the center, so transmission differs across the frame. The pattern that results is the cross.
The behavior follows from the construction, so it is present across variable ND filters generally.