Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

Why does my variable ND shift colors, and can I correct it?

Validated 13 November 2026

Applies to

Line
Filters
Attribute
Variable ND

Resolution

  1. 01

    Set the density first and leave it there. On a variable ND the density is set by rotating the ring, and the correction you are about to make belongs to the setting you finish on.

  2. 02

    White balance through the filter at that density. Fill the frame with a gray card lit by the light you are shooting in, with the filter fitted and set, and take a custom white balance from it.

  3. 03

    Shoot a reference frame at the head of each setup: the gray card, in the light, at that density. It gives the grade a known neutral to pull from later.

  4. 04

    Repeat steps 2 and 3 whenever you move the density. A balance taken at one density describes that density.

  5. 05

    Record in RAW or in a log format where the camera offers it, so the correction stays a white balance change in the grade.

  6. 06

    Check the density and the focal length where the shift varies from one part of the frame to another. Tiffen states the X Bar Effect appears with all variable ND filters at dark densities and wide focal lengths, and clears when you lighten the density, zoom in, or both.

  7. 07

    Use a fixed ND where a shot has to stay neutral across several densities. Tiffen's neutral density range includes the NATural ND line, described at https://tiffen.com/pages/natural-nd-edu

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question