Does drop time change when the rig is inverted for low mode?
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Any sled
Resolution
- 01
On a mechanical sled, yes: the drop time is re-established in the opposite direction so the camera falls to the bottom of the rig.
- 02
Balance the sled first, exactly as in high mode. Hang the rig by its gimbal on the balancing stud, with the camera on top and upside down, and set static and dynamic balance.
- 03
Then move the gimbal to invert the sled. On the Zephyr and Scout, slide the gimbal toward the electronics until you have a proper drop time. On the Aero, find neutral and move the gimbal 1/2 inch away from the stage.
- 04
Use the sled length to get lens height. Extending the post and lowering the gimbal is the published way to add lens height or go lower in low mode.
- 05
Use a deliberately longer drop time only as a lens-height tool. Tiffen's published levers for lowering the range of low mode lens heights are extending the center post and making the rig more bottom heavy.
- 06
On a Volt-equipped rig, do not rebalance. The sled is already neutral top-to-bottom, so Tiffen states there is no rebalancing needed when switching to low mode. Allow approximately 20 seconds for the horizon to stabilize after the switch, and note that the Volt stores independent level trims for low mode and high mode.
Cause
The drop time measures the offset between the sled's center of gravity and the gimbal bearings, and the useful state is for the center of gravity to sit on the far side of the gimbal from the camera.
Inverting the camera moves it to the other side of the gimbal, so the offset that was correct in high mode is now on the wrong side. Sliding the gimbal across the center of gravity puts it back, which is why the correction is a gimbal move in the opposite direction, with the count itself unchanged.
A Volt rig sits at neutral in both modes by design, so there is no offset to reverse.