Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

The sled arcs away from my body and I am fighting the arm.

Validated 13 November 2026

Applies to

Line
Steadicam
Attribute
Any arm

Resolution

  1. 01

    Stand up straight with the rig off your operating hip, in good posture and without tension. Do not let go of the sled completely, but let it move a little.

  2. 02

    Check your posture first. Leaning forward makes the sled move away from you quickly. Keep the torso vertical and lean back slightly as the sled moves further out.

  3. 03

    If the sled still moves away from you after posture is correct, adjust the in-out screws on the vest socket block. Loosen the bottom screw and dial the upper screw in a few turns, then snug the lower screw and re-test.

  4. 04

    If the sled moves toward you, do the opposite: loosen the upper screw a few turns, snug the lower screw, and re-test.

  5. 05

    Work in small increments and re-test after each one, until the sled stays in place or floats next to you with the torso vertical.

  6. 06

    Count the threads showing on each screw and write the numbers down. That is your setting, and it lets you rebuild it in seconds on the next job.

  7. 07

    Leave the side-to-side screws alone while doing this. The published fault here is the in-out pair.

  8. 08

    Stop adjusting once the rig is close. Tiffen's own guidance is that most of this is learning to stand and move correctly.

Cause

The arm meets the vest through an adjustable socket on the arm and a female socket block on the vest. Two adjustment screws in the socket block and two rod ends in the arm set the angle of that joint, which Tiffen calls the threads.

That angle decides the direction in which the arm's lifting force acts relative to your body. Angled so the force has a forward component, the arm drives the sled away from you and you spend the shot pulling it back. The screws rotate the socket block until the force is vertical for your posture, at which point the sled stays where it is put.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question