Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

How do I set static balance, step by step?

Validated 13 November 2026

Applies to

Line
Steadicam
Attribute
Any sled

Resolution

  1. 01

    Add your batteries and bottom weight before anything else. That way by adding the camera the Sled is not top heavy

  2. 02

    Fit the camera to the dovetail plate. Find the camera's fore-aft and side-to-side center of gravity (CG) , then attach the dovetail so the CG of the Camera is sitting over the back half of the post.

  3. 03

    Pull the aircraft pin, take the sled off the docking bracket, and place the gimbal's mounting hole on the balancing stud.

  4. 04

    Set top-to-bottom position. Rotate the center post to horizontal and grasp it securely. Open the gimbal clamp and slide the post through the gimbal until the sled balances on the gimbal like a seesaw.

  5. 05

    From that seesaw point, slide the post through the gimbal about 1/2 inch (12mm) up. This puts the sled's center of gravity 1/2 inch below the gimbal yoke bearings and makes the sled slightly bottom heavy. Close the gimbal clamp.

  6. 06

    Set fore-aft balance. Look at the sled from the side with the post vertical. Turn the fore-aft knob on the stage until the camera is level.

  7. 07

    Set side-to-side balance. Look at the sled from the front or rear and turn the side-to-side knob until the center post is vertical. A bubble level helps on both axes.

  8. 08

    Set the drop time. Check the dovetail locking knob is tight, rotate the sled to horizontal, let go of the center post, and count the seconds until the post falls through vertical. Correct by sliding the post through the gimbal about 1/8 inch (3mm) with the rig horizontal, and re-test.

  9. 09

    Recheck fore-aft and side-to-side by eye and trim with the stage knobs. Changing one axis moves the others, so expect to work around the three axes more than once.

  10. 10

    If the sled will hang upside down when you release it, stop. That is the published symptom of a camera weight beyond the sled's specification. Extend the post first, and if that does not correct it, reduce the camera weight.

  11. 11

    If the camera is very light, add mass before balancing: a larger battery, an audio receiver, or balance weights added symmetrically beneath the stage. This keeps the gimbal close to the stage and loads the arm properly.

Cause

Static balance is defined as the sled hanging with the central post vertical at rest, whatever position the gimbal occupies on the post. Reaching that state means the sled's center of gravity sits directly under the gimbal in the fore-aft and side-to-side axes.

The top-to-bottom axis carries a deliberate offset, and that offset is a compromise. A top heavy sled tips over. A sled that is too bottom heavy hangs upright but is hard to tilt and hard to control on the move. A neutrally balanced sled cannot be trimmed fore-aft or side-to-side at all, because there is no restoring torque for the trim knobs to work against, so the operator does all the aiming. The 1/2 inch offset sits between those.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question