Why is the gimbal unbalanced with the Volt fitted?
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Volt
Resolution
- 01
Expect an offset and do not chase it. A gimbal with a Volt fitted cannot be center balanced to the factory precision, and Tiffen states that this level of precision is unnecessary once the Volt is running.
- 02
Confirm the balance weight is present. A balance weight is installed on the pulley side of the Volt motor drive specifically to bring the gimbal into static balance with a Volt installed.
- 03
Turn the Volt on before judging the rig. With the Volt turned on and operating, a slightly out of balance or slightly un-dynamically balanced sled has little to no effect on operating.
- 04
Expect more visible offset on a neutral sled than on a bottom-heavy one. A neutrally balanced sled shows more balance offset than one with a 2 to 3 second drop time, because it is more sensitive to imbalance and to the friction from the Volt motors and belts.
- 05
Check for added friction if the gimbal feels stiff. On M-1, Archer, Shadow and other manufacturers' gimbals, confirm the Volt pan encoder is spaced the thickness of a folded piece of paper from the magnetic encoder ring. On M-2 units, confirm the encoder mounting screws and the two set screws filling unused pulley holes are not over-tight, since they can deform the gimbal bearing and add drag.
- 06
Run the normal three-step Volt balance: static with a 2 to 3 second drop time, then dynamic, then fully neutral.
- 07
Contact Tiffen Steadicam service if the offset is large enough that the sled cannot be brought upright, or if the gimbal came back from service in this state.
Cause
Center balancing is a factory operation performed with the Volt removed. The gimbal yoke is shimmed left or right in increments of .001 to .002 inch so that the pan axis and the roll axis of the gimbal intersect, and Tiffen describes the precision required as within the thickness of a human hair or less.
Fitting a Volt adds a motor drive, pulleys, belts and an encoder ring to one side of that gimbal. The added mass and the belt friction sit outside the shimmed condition, so the assembled gimbal falls outside the factory tolerance. The Volt motors then supply the correction that the mechanical precision used to supply, which is why the residual offset stops mattering once the system is powered.