Why is my horizon drifting with the Volt fitted?
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Volt
Resolution
- 01
Work through the five mechanical items Tiffen names, in this order: tilt and roll pulley mounting screws, the Volt motor drive on the gimbal yoke, the gimbal handle, the belts, and the Volt control box mounting.
- 02
Check the belts by pinching one halfway between the motor and the pulley and twisting it. Past 45 degrees the belt is too loose. Precise tension is not critical for operation.
- 03
Confirm the control box is rigidly mounted to the stage and cannot shift.
- 04
Check your power-up alignment. With the control box knobs on the right, align the gimbal handle with the rear of the post. With the knobs on the left, align it with the front of the post. On a sled with an internal Volt board, align with the rear of the post whichever side the knobs are on.
- 05
Allow the control box to warm up. Wait 3 to 4 minutes after powering up from cold before storing a new trim.
- 06
Re-store the trim if the mounting of the control box has physically shifted. Short-press the trim button and position the sled at the new level position while the LEDs blink for 5 seconds. When the blinking stops, the new horizon is stored.
- 07
Long-press the trim button for 6 seconds to reset the roll horizon to default, until both LEDs on the control box turn off and pulse back on.
- 08
Allow about 20 seconds for the horizon to stabilize after switching between low mode and high mode. The Volt stores independent level settings for the two modes.
- 09
Check whether you are inside the Volt's roll range. It controls roll up to plus or minus 25 degrees, with reduced power applied to the roll motor beyond plus or minus 5 degrees.
- 10
Confirm the supply is stable and above 12V. The Volt operates from 12 to 17 Vdc.
- 11
Contact Tiffen Steadicam service if the drift persists after all of these.
Cause
The Volt reads its own attitude at the control box and drives the sled through the tilt and roll pulleys, the belts and the motor drive on the gimbal yoke. Every one of those is a rigid mechanical reference.
A loose screw anywhere in that chain lets a part move relative to another under load. The sensor then reports a level rig while the camera has actually moved, or the motors turn the pulley without turning the gimbal by the same amount. Either way the correction and the reality drift apart, which is why Tiffen's published answer is a list of fasteners to check.