Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

Why does my sled lose balance every time I remove and refit the camera?

Validated 13 November 2026

Applies to

Line
Steadicam
Attribute
Solo

Resolution

  1. 01

    Take the camera off with the dovetail plate still attached to it. The dovetail stays on the camera between setups; only the dovetail leaves the stage.

  2. 02

    Leave the fore-aft and side-to-side trim knobs on the stage alone. Those two knobs carry your balance setting; touching them while the camera is off loses it.

  3. 03

    Note where the dovetail sits in the stage before you remove it. On stages with index marks on the dovetail plate, read the mark and return to it. Otherwise mark the position with tape.

  4. 04

    Refit the camera by returning the dovetail to that same position, then tighten the dovetail locking knob fully before releasing the camera weight. Support the camera weight with one hand as you lock the dovetail.

  5. 05

    Verify the dovetail locking knob is tight before every drop test. A dovetail that creeps under load moves the camera and changes all three axes.

  6. 06

    Check what else changed with the camera. A different camera battery, a lens, a filter, a matte box or a rod-mounted accessory all move the center of gravity, and the manual states plainly that adding any accessory changes both static and dynamic balance. Rebalance statically after such a change.

  7. 07

    If you removed the camera's own battery while finding the center of gravity, refit it before balancing and keep it fitted afterward.

  8. 08

    Contact Tiffen Steadicam service if the dovetail slides in the stage while the locking knob is fully tight.

Cause

The dovetail plate is the part that carries the balance setting. It is screwed to the camera at a position determined once, with the second slot from the rear over the camera's center of gravity, and it then locates the camera in the stage the same way every time.

Balance is lost when something in that chain changes: the dovetail is unscrewed from the camera, the plate is refitted at a different point along the stage, the stage trim knobs are turned while the camera is off, or the dovetail lock is not fully tight and the plate creeps under load.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question