How do I assemble and set up low mode?
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Any sled
Resolution
- 01
Please note that while certain cameras cant be flipped upside down and needs to be underslung but by today's standards most digital cameras can simply flip their sensor.
- 02
Flip the monitor. Unscrew the monitor mount, turn the monitor over and replace the screw. Alternatively leave the monitor as it is and flip the image electronically.
- 03
Attach the F-bracket to the gimbal handle by inserting its post into the gimbal handle and securing it with the supplied pin. On the Aero, always use the stainless steel pin included with the F-bracket. The published parts are F-bracket 300-7901, or low mode kit 078-7393-01 which contains the F-bracket and handle clamp.
- 04
Extend the center post
- 05
Rebalance statically and dynamically with the rig hanging by its gimbal on the balancing stud. The camera is still on top, upside down.
- 06
Reset the drop time in the inverted sense so the camera now falls to the bottom of the rig. On the Zephyr and Scout, slide the gimbal toward the electronics. On the Aero, find neutral and move the gimbal 1/2 inch away from the stage.
- 07
Restore the arm's boom range if it is short. Change to a longer post in the arm, or raise the socket block on the vest, or both.
- 08
Lower the range of lens heights further, if the shot needs it, by extending the center post or making the rig more bottom heavy.
- 09
On a Volt-equipped rig, skip the rebalance. Tiffen states that no rebalancing is needed when switching to low mode with Volt fitted. Allow about 20 seconds for the horizon to stabilize after the switch.
Cause
Inverting the camera moves it to the underside of the gimbal, so the sled's center of gravity moves to the other side of the gimbal bearings. The drop time therefore has to be re-established in the opposite direction, which is why the gimbal moves toward the electronics.
The F-bracket exists because the gimbal handle ends up alongside the camera once the sled is inverted. It offsets the arm post from the handle and restores the geometry between the arm and the sled, which is what makes hand switches possible in low mode.