How is the monitor mounted and oriented in low mode?
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Any sled
Resolution
- 01
Decide between the two published options before you start. Either physically flip the monitor so the image reads correctly, or leave the monitor as it is and flip the image electronically.
- 02
To flip the monitor physically on a Zephyr or Scout, unscrew the monitor mount, turn the monitor over, and replace the screw.
- 03
On an Aero, adjust the monitor so it is visible when the sled is inverted, as part of the same step that extends the post and adds weights to the cross rod.
- 04
If you invert the camera and leave the image inverted, plan for it. Tiffen notes that this requires inverting the image in the edit as well as on monitors at location, so confirm that is acceptable before the shoot.
- 05
Rebalance after any monitor change. Moving the monitor in or out, or changing the sled length, changes both static and dynamic balance.
- 06
Check the rod interface before buying a third-party monitor or bracket. The M-2 monitor mount uses industry-standard 60mm rod spacing, and the Axis uses 15mm rods at 60mm spacing with M12 threaded ends.
- 07
Contact Tiffen Steadicam service with your sled model and monitor model for a low mode bracket recommendation, since none is published.
Cause
Inverting the sled turns the monitor upside down along with everything else on the base, so the image reads inverted to the operator. Turning the monitor over on its mount corrects the display without touching the signal; flipping the image in the monitor corrects the display without touching the hardware. Both reach the same result and each costs something different: one is a mechanical step at the rig, the other propagates an inverted feed to every other monitor on location.