Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

What does the 12V/24V switch actually do?

Validated 13 November 2026

Applies to

Line
Steadicam
Attribute
M-1, M-2

Resolution

  1. 01

    Understand what the switch changes: it rewires the two batteries to each other. In the 12 Volt position the front and rear batteries are wired in parallel. In the 24 Volt position they are wired in series.

  2. 02

    Expect battery voltage at the output, because nothing regulates it. On the M-1 the 12V output varies approximately from 11 to 17 volts with typical lithium-ion batteries, and the 24V output between approximately 22 and 34 volts. On the M-2 the 12V output is typically around 14.4V and the 24V output around 29V.

  3. 03

    Read your device's input range before selecting 24V. Compare it against the figures above. The marking on the connector names the nominal cell arrangement, so meter the port for the value actually present.

  4. 04

    Note that 24V mode adds a rail. On the M-2, 12 volts is supplied at all times on the 12/24V ports, and 12 and 24 volts are present simultaneously when the switch is in 24V mode.

  5. 05

    Check the mount position before switching to 24V.

  6. 06

    Use batteries at a similar state of charge. Tiffen states it is best to avoid mixing charged and discharged batteries on the same switch.

  7. 07

    On the M-2, keep the three switches distinct. The main ON-OFF switch turns power on and off for everything except the P-taps on each battery mount. The main 12V/24V switch adds battery number 2 in series or parallel with battery number 1. The third battery switch, on the side of the main battery mount, does the same for the optional third battery.

Cause

The switch is a wiring change and there is no converter behind it. Two batteries in parallel present the voltage of one battery at twice the available current. The same two in series present twice the voltage at the current of one.

Because the output follows the pack directly, the numbers 12 and 24 name the nominal cell arrangement and not a fixed rail. A single pack sitting at 16.8 volts fresh off the charger puts 16.8 volts on a nominal 12V port and 33.6 volts on the nominal 24V port.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question