What do I check before powering a camera or monitor from the sled?
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Steadicam M-1, Steadicam M-2
Resolution
- 01
Read the device's input voltage range. It is printed on the device or stated in its manual, normally as a range.
- 02
Establish what the sled output will actually carry. On the M-1 the 12V output varies with the battery, approximately 11 to 17 volts with typical lithium-ion cells. On the M-2 the 12V output is typically around 14.4 volts and the 24V output around 29 volts. Compare those figures against the device's range before connecting.
- 03
Check the mount position before switching to 24V. In 24V mode, mount a sandwiched accessory only on the rear battery mount. Mounting one on the front mount in 24V mode creates a live ground condition that damages the accessory or other components. In 12V mode either mount is safe.
- 04
Check the current draw against the port. P-Tap connectors are limited to 5 amps each and are protected by self-resetting fuses. Confirm the accessory's rating before powering it from a P-Tap. On the M-1 the stage P-Taps are switched and the base P-Taps are not.
- 05
Do not expect power from an ISO port. The ISO connectors on the stage and base are isolated from the power system, carry no power from the batteries, and are not controlled by the power switch.
- 06
Meter any third-party or repaired cable before first use. With the cable disconnected from the device, confirm voltage and polarity at the device end.
- 07
Contact support with the sled model, the battery, the device and the cable if any value above cannot be confirmed for your rig.
Cause
The 12V and 24V outputs are not regulated. The 12/24V switch changes how the two batteries are wired to each other, in parallel for 12V and in series for 24V. The voltage at the output follows the batteries. There is no fixed rail.
A device connected to a nominal 12V port therefore sees whatever the pack is sitting at, which on the M-1 can reach approximately 17 volts. A device whose input range stops below that is outside specification while the connector still fits.