Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

Why did connecting a monitor to the sled output destroy it?

Validated 13 November 2026

Applies to

Line
Steadicam
Attribute
M-1, M-2

Resolution

  1. 01

    Record what was connected to what before anything else: the sled model, the port used, the switch position at the time, the cable, and the monitor's rated input range. Tiffen service will ask for all five.

  2. 02

    Compare the monitor's rated input against what the port actually carries. Sled outputs are unregulated, so the voltage present is battery voltage: approximately 11 to 17 volts on an M-1 nominal 12V output, typically around 14.4V on an M-2, and approximately 22 to 34 volts on an M-1 nominal 24V output. A monitor rated for a narrow 12V input can see up to approximately 17 volts on a nominal 12V port.

  3. 03

    Check whether the port carried 24V. On the M-1, the 12/24V LEMO and the CAM PWR connector both expose +24V on pin 3 alongside +12V on pin 2. On the M-2, the 12/24V ports carry 12 and 24 volts simultaneously when the switch is in 24V mode. A cable wired to pin 3 on one of those ports delivers the 24V rail.

  4. 04

    Check the cable. On a made or repaired cable, meter the device end with the cable disconnected from the monitor and confirm both voltage and polarity against the pin table for that port. The M-1 stage and base post connectors mate together and are mirror images of each other, which makes pin numbering easy to get backward.

  5. 05

    Use the monitor port for the monitor. On the M-1 the MON PWR connector is published as pin 1 power ground, pin 2 +12V, pin 3 tally, pin 4 RX, pin 5 TX, with no +24V pin listed. On the M-2 the monitor port is a LEMO 5-pin 1B carrying power and tally.

  6. 06

    Contact Tiffen Steadicam service with the five items from step 1. Note that the Steadicam warranty excludes damage from cables and other non-originally-supplied Steadicam accessories.

Cause

The 12V and 24V outputs are unregulated. The 12/24V switch changes how the two batteries are wired to each other, in parallel for 12V and in series for 24V, and the voltage at the output follows the pack. There is no fixed rail.

Two failure paths follow from that. A device rated for a narrow 12V input can see up to approximately 17 volts on a nominal 12V port with a fresh pack. And on the connectors that expose both rails, +12V on pin 2 and +24V on pin 3 of the same LEMO, a cable wired to the wrong pin delivers roughly twice the intended voltage to a device whose connector fits perfectly.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question