Why does sled power drop to a lower voltage and then recover?
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Any sled
Resolution
- 01
Record what is happening before changing anything: which ports drop, the voltage before and after the drop, whether the drop repeats at the same value, and whether the rig is in 12V or 24V mode.
- 02
Check what is drawing current from each port. Add up the rating of every accessory on the sled. P-Tap connectors are limited to 5 amps each and are protected by self-resetting fuses. On an M-1 the base P-Taps are further limited by fuses in the battery mounts, typically 5 amps for IDX V-Lock and 10 amps for Anton Bauer.
- 03
Remove every accessory except the one that fails, and reproduce the fault. Add the others back one at a time.
- 04
Fit two freshly charged batteries of the same brand and the same charge state. Tiffen states it is best not to mix charged and discharged batteries, and recommends name brand Anton Bauer or IDX cells.
- 05
Confirm what the port is actually supposed to deliver. Sled outputs are unregulated, so the voltage present is battery voltage, typically 11 to 17 volts on a nominal 12V port and around 29 volts on an M-2 in 24V mode. On the M-2, 12 volts is present on the 12/24V ports at all times, and 24V mode adds 24 volts alongside it.
- 06
Confirm the rig is wired for the voltage you expect. A Zephyr ships as a single-mount 12V sled and 24 volts is an option, so a two-battery Zephyr without the 24V option will read near 12V whatever the camera expects.
- 07
Meter the drop at two points at once if you can: at the battery terminals and at the device end of the cable. A drop present at the device and absent at the battery is in the cable, the connector or the post wiring.
- 08
Flex each cable and each connector while metering. A fault that appears under movement and tests clean at rest will not reproduce on a bench.
- 09
Check the Volt separately if one is fitted. Volt is designed for 12 to 17 Vdc, motor systems switch off below 12V, and motor power returns automatically once voltage recovers. Tiffen's published remedies are batteries in parallel, a third battery mount, or a dedicated battery for the Volt.
- 10
its raw voltage, it depends on what the camera and monitor need to function
- 11
refence the sleds manual
- 12
Send us the sled model, the battery model and mount, the 12V or 24V mode, the port, the accessory, and the two voltages you measured in step 7.