Is a long slow rocking settle after a balance adjustment normal?
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Any sled
Resolution
- 01
Time the drop before judging the settle. Rotate the sled to horizontal on the balance pin, release the post, and count the seconds until it passes vertical.
- 02
Compare the count against the figure published for your rig. A long slow rock and a long drop time are the same condition read two ways: the slower the drop time, the less bottom heavy the sled.
- 03
If the count is inside the published target, the settle is normal and needs no correction. Nothing in the gimbal damps the swing, so a lightly loaded sled continues to rock for some time on the balance pin.
- 04
If the count is longer than the published target, move the gimbal about 1/8 inch (3mm) closer to the stage with the rig horizontal, close the clamp, and re-test.
- 05
Expect to re-trim fore-aft and side to side after any change here. Tiffen states that the sled becomes more sensitive as the drop time slows.
- 06
Damp the swing with your hand while you read the trim. Keep at least one hand on the sled at all times while it is on the balance pin.
- 07
Expect the settle to disappear when you fly the rig. In operating, the left hand on the post supplies the damping, and Tiffen's published grip uses the pinkie finger specifically to prevent a pendulum effect.
Cause
The sled hanging on the gimbal is a pendulum. Its restoring torque comes from the offset between the sled's center of gravity and the gimbal bearings, which is the same quantity the drop test measures.
A small offset gives a weak restoring torque, which gives a long swing period and a long settle. There is no damping element in the gimbal, so the energy in the swing leaves only through bearing friction and air, which is slow. In use, the operator's fingers on the post provide the damping instead.