My sled spins about its own axis during the drop test.
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Any sled
Resolution
- 01
Separate the two motions before you diagnose anything. The drop time is the count from release until the post passes through vertical. Rotation of the sled about the post is a different axis and does not change that count.
- 02
Repeat the drop test and watch only the post as it falls. If the count is inside the target for your rig, the drop time is set correctly whatever the sled does in pan.
- 03
Check how you are releasing the sled. The pan axis is free by design and carries no restoring force, so any twist applied at the moment of release keeps turning. Release the post with an open hand and no sideways push.
- 04
Check the routing of any cable that crosses the gimbal. A cable pulled taut between the stage and the base applies a torque about the post. Leave slack at the gimbal.
- 05
Now watch the post while the sled rotates. If the post stays vertical through the rotation, the rig is in dynamic balance and nothing is wrong. If the post tips as the sled rotates, that is a dynamic balance error: move the battery in or out, rebalance statically with the camera, and spin again.
- 06
If the sled starts to pan as soon as you tilt it, trim the stage side to side until the pan stops. A small left-right imbalance couples tilt into pan.
- 07
Increase pan inertia if the rotation is a problem while operating rather than while balancing. Moving the battery and monitor further out from the post raises the inertia of the pan axis and slows unwanted rotation.
Cause
The pan axis of a Steadicam gimbal is free. Nothing in the sled applies a restoring torque about the post, and on a Volt rig the motors control tilt and roll only, so pan is uncontrolled there as well. A sled left to itself will therefore keep any rotation it was given.
Drop time is measured against a different axis. The count runs from the moment the post is released at horizontal to the moment it passes vertical, so rotation about the post neither speeds nor slows it.