Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

The rig balances at one rotation and leans at the opposite one.

Validated 13 November 2026

Applies to

Line
Steadicam
Attribute
Any sled

Resolution

  1. 01

    Confirm you are comparing like with like. Rotate the gimbal handle back to the same orientation each time you read the balance. On the Axis, align the gimbal grip line with the back of the post, and confirm the yellow index lines on the gimbal and post align exactly before closing the clamp.

  2. 02

    Re-run static balance at your normal orientation: fore-aft, then side to side, then drop time, then re-trim the first two.

  3. 03

    Rotate the gimbal 180 degrees about the post and read the sled again without touching the trim knobs. Record how far it leans and in which direction.

  4. 04

    Run the dynamic balance spin at 3 to 6 rpm. If the post tips as the sled pans, correct dynamic balance first: move the battery in or out, rebalance statically with the camera, and spin again until the sled pans flat.

  5. 05

    Tilt the sled and let go. It should stay at the angle you left it. If it rotates while tilted, make a small side-to-side trim at the stage.

  6. 06

    If the lean persists at the opposite rotation after static and dynamic balance are both correct, the symptom points at gimbal center balance. That is a factory operation in which the gimbal yoke is shimmed left or right in increments of .001 to .002 inch so the pan axis and the roll axis intersect. It is not an operator adjustment.

  7. 07

    If a Volt is fitted, expect some residual offset and do not chase it. A gimbal with a Volt fitted cannot be center balanced to the factory precision, and Tiffen states this is expected. With the Volt turned on, a slightly off center or slightly un-dynamically balanced sled has little to no effect on operating.

  8. 08

    Contact Tiffen Steadicam service with the sled model, the gimbal model, and the measured lean if the rig came back from a service with this behavior.

Cause

The trim knobs on the stage move the camera relative to the post. They correct the position of the center of gravity in the sled's own frame of reference.

Center balancing is a different adjustment, made to the gimbal itself: the yoke is shimmed so that the pan axis and the roll axis of the gimbal intersect. When they do not intersect, the gimbal's own pivot point sits to one side of the post's axis, so rotating the gimbal 180 degrees moves that offset to the other side and the sled leans the opposite way. No amount of stage trim removes it, because the stage trim and the gimbal offset are in different frames.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question