Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

What does the Volt do, and does it change how I rebalance?

Validated 13 November 2026

Applies to

Line
Steadicam
Attribute
Volt

Resolution

  1. 01

    Know what the Volt controls. It works with the sled's inertia and neutral balance to generate an artificial bottom-heaviness that keeps the horizon level and headroom stable. It controls two of the three rotational axes, tilt and roll. The pan axis stays entirely with the operator and is governed by the inertial mass of the sled. The Volt 3 adds Pan Axis stabilization.

  2. 02

    Know its roll range. The Volt is designed to control roll up to plus or minus 25 degrees, with reduced power applied to the roll motor beyond plus or minus 5 degrees.

  3. 03

    Balance in three steps. First static balance so the sled hangs upright and slightly bottom heavy, with the drop time at about 2 to 3 seconds. Second, dynamic balance at that setting. Third, take the top-to-bottom balance fully neutral with no drop time at all.

  4. 04

    Remove the gimbal cable and leave the sled powered off while you dynamic balance. The cable prevents the rig spinning freely and can be damaged.

  5. 05

    Reconnect the cable and power up once the balance is finished.

  6. 06

    Rebalance the same way after any change above the gimbal. Restore a normal drop time, rebalance, then go fully neutral again.

  7. 07

    Skip the low mode rebalance. With Volt fitted there is no rebalancing needed when switching to low mode, because the sled is already neutral.

  8. 08

    Trim headroom electronically. Leave the rig neutrally balanced and trim with the Volt controls or by tilting the tilt head and storing a new trim. Trimming for headroom with the stage knobs works against the neutral state the Volt needs.

  9. 09

    Do not chase perfect static balance. With Volt 3, the rig can be off by 10 degrees or more and the motors will correct it when active.

Cause

Neutral balance is what the Volt substitutes for. A mechanical sled uses bottom-heaviness to supply the restoring torque that keeps the post upright, and that torque is also what makes the sled swing under acceleration and what the operator has to fight when tilting. The Volt applies that restoring torque with motors instead.

Tiffen states two mechanical reasons for the neutral requirement. A neutrally balanced sled takes very little force to move in any direction, so the motors respond faster and draw less power. And a neutrally balanced sled does not pendulate as it accelerates or decelerates, so the motors have less work to do to keep the sled at the right attitude while the rig is moving.

Dynamic balance matters for the same reason: a sled in dynamic balance pans flat with no input from the operator or the Volt, so the motors are left with less compensating force to apply, particularly on whip pans.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question