What drop time should I set, and how do I physically reach it?
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Any sled
Resolution
- 01
Place the sled on the balance pin of the dock and confirm the dovetail locking knob and the post clamps are tight.
- 02
Rotate the sled to horizontal on the balance pin. Release the post and count the seconds until the post passes through vertical. That count is the drop time.
- 03
The average desired drop time is about 3 seconds but this can change depending on the preference of the operator. Please note that any Sled with a volt requires a 0 second drop time (Neutral balance) for the volt to perform properly
- 04
Correct the count by moving the gimbal along the post. With the rig horizontal, open the gimbal clamp and slide the center post through the gimbal about 1/8 inch (3mm). Move the gimbal up the post for a faster drop time and down the post for a slower drop time.
- 05
Close the gimbal clamp and repeat the drop test. Keep the adjustments small.
- 06
Recheck fore-aft and side-to-side balance and trim with the stage knobs. As the drop time lengthens the sled becomes more sensitive, so expect to re-trim.
- 07
If a Volt or Volt 3 is fitted, treat the 2 to 3 second setting as an intermediate step. Dynamic balance the rig at that setting, then take the top-to-bottom balance fully neutral with no drop time before you fly.
- 08
Tiffen gives 1 to 4 seconds as the usable range: a longer drop time for easier tilts and rapid accelerations, a shorter one for static horizons or wind.
Cause
Drop time measures how far the sled's center of gravity sits below the gimbal yoke bearings.
Moving the gimbal along the post changes that distance, and the distance sets the restoring torque that swings the post back to vertical. A larger offset means more torque and a faster swing, which is a shorter count. A smaller offset means less torque and a slower swing. That is why the correction is sometimes a gimbal move and somtimes a weight change.