What is dynamic balance, and do I need it for what I shoot?
Validated 13 November 2026
Applies to
- Line
- Steadicam
- Attribute
- Any sled
Resolution
- 01
Get the sled into static balance first with a normal drop time. A rig with poor static balance cannot be dynamically balanced.
- 02
Set the sled length for the shot and place the monitor where you want it for viewing and inertia. Leave the monitor there for the rest of the procedure.
- 03
Position the camera so its center of gravity sits about 1/2 inch (12mm) behind the center post, then static balance by sliding the battery in or out until the post hangs vertical fore and aft.
- 04
Spin the sled on the balance pin. Keep the spin slow, no faster than a normal panning speed, which Tiffen gives as 3 to 6 rpm. Watch whether the post stays vertical or wobbles.
- 05
If the post wobbles, move the battery a little. Do not move the monitor. Note the direction you moved it.
- 06
Rebalance statically with the camera after every battery move, then spin again. Repeat until the sled pans flat. When the battery is within about .25 inch (6mm) of ideal the sled pans flat.
- 07
Judge whether you need this precision for the shot. Tiffen states that precise dynamic balance is optional on a mechanical sled depending on the shot, and worth doing when the day has many pans or when you are setting up at the start of a day. Whip pans are the case where it matters most.
- 08
Treat it as required if a Volt is fitted. On a Volt rig, dynamic balance reduces the force the motors must apply and lowers their power draw.
- 09
Once you are in dynamic balance, change only one thing at a time. Change something above the gimbal, such as a lens or a filter, and rebalance with the camera. Change something at the base, such as battery size or balance weights, and rebalance at the base.
Cause
Static balance fixes where the sled's center of gravity sits relative to the gimbal. It does not fix how the sled's mass is distributed around the pan axis.
For any one arrangement of camera, monitor position, post length and accessories there are many positions that satisfy static balance and exactly one that also pans flat. A sled that satisfies static balance alone will tip its post away from vertical as it pans, because the mass distribution feeds a rotation in one axis into a rotation in another.
Camera weight does not enter into it. Changing camera, lens or filters requires a fresh static balance only; the dynamic condition survives.