Skip to content
Support

Filters, Steadicam, Domke, Lowel, Davis & Sanford, Zing.

What is the minimum balance state before I can usefully fly the rig?

Validated 13 November 2026

Applies to

Line
Steadicam
Attribute
Any sled

Resolution

  1. 01

    Complete static balance in all three axes before you fly anything. This is the minimum: the sled hangs upright with the post vertical, fore-aft and side to side, and the drop time is inside the figure published for your rig.

  2. 02

    Confirm the sled hangs more or less upright before you release it on the balance pin.

  3. 03

    Set the arm lift next. Each arm section should float about 5 to 10 degrees above horizontal at mid boom, forearm first, upper arm tracking it.

  4. 04

    Set your vest threads so the rig stays put when positioned slightly to your operating side. Without this the arm drives the sled toward or away from you for the whole take.

  5. 05

    Defer dynamic balance if the shot allows. Tiffen states that precise dynamic balance may not be needed depending on the shot, and is worth doing when the day has many pans or when you are setting up at the start of a day. Whip pans are the case where it matters most.

  6. 06

    Do not defer it on a Volt rig. On a Volt rig the balance sequence is static with a 2 to 3 second drop time, then dynamic, then fully neutral, and the neutral state is the one you fly.

  7. 07

    Return and do the dynamic balance once the sled build is settled. Note the monitor and battery positions so you can rebuild the state quickly on the next job.

Cause

Static balance and dynamic balance answer different questions and the first is a precondition for the second. Static balance puts the sled's center of gravity directly under the gimbal in two axes and slightly below it in the third, which is what makes the rig hang upright and what makes the trim knobs work at all. A rig without it cannot be dynamically balanced, because every spin reading is contaminated by the static error.

Dynamic balance is about how the mass is arranged around the pan axis, and its effect shows up only while the sled is panning. A rig in static balance alone flies acceptably for shots without significant pans, which is why Tiffen frames it as shot-dependent on a mechanical sled. On a Volt rig the motors have to supply whatever the dynamic error asks for, so leaving it unset costs response and battery.

Ask us about thisSend your question and this article travels with it, so the answer starts where the article stopped.Send us the question